IZOFLEX

Installation

All works should be done in rainless day, in temperature 10-20^oC. Minimal temperature shouldn’t be lower than +5^oC.

1. From the top of the surface where we stick tiles, measure two horizontal lines at a distance calculated by. formula: 4 x width of tile + 3 x joints 10-12 mm..
2. IZOFLEX-SK glue should be applied with tooth notched trowel 4 x 4 mm, preparing the ground for four rows of tiles at a time.
3. Sticking starts from the top of the wall, starting with corners first. The tiles flex as needed.
4. The tile is determined by the binding of bricks on the wet glue, pressing evenly, with appropriate joints.
5. Additional jointing is superfluous, just smooth the glue in joints with a wet (but not too wet) brush (10 mm) Done!
6. The tiles IZOFLEX are cut to size with scissors.
7. The resulting stretch marks on the corners, fill with a special mass.

Short installation movie:


Comments:
- freshly plastered walls prevent from rain to dry.
- not suitable for sticking on horizontal surfaces
- tools should be cleaned with water immediately after use